When we are using electronic scales, there will be random jumps in numbers. Do you know what happened? The following reasons are the reasons for the random jumps of Wuhan electronic scales.

　　1. The power supply is unstable. If the power supply is unstable, it will cause the device's normal voltage range to be exceeded, and the phenomenon of digital jumps will occur, so a better stable voltage needs to be configured.

　　2. The junction box is not well sealed. If the humidity in the box is high, open the junction box to observe whether there is water droplets or moisture. After the wind blows over, the fault can be eliminated. If necessary, a new junction box needs to be replaced.

　　3. The main line of the electronic scale is damaged. If the scale is kicked farther away from the meter, the main line will leak outside. It will be affected by external factors, and the phenomenon of shielding or unstable connection will occur, causing the phenomenon of digital jumps.

　　4. The sensor of the electronic scale is damaged. When the sensor is damaged or drifting, it will also cause the phenomenon of digital instability. In general, if one sensor is damaged, you can determine the specific fault. You can directly connect the main line to remove all the sensors one by one. , And then slowly connect the sensor, while observing whether the display on the meter is normal, you can judge whether the sensor is normal.

　　Through the conclusion of the above content, I believe that everyone has a certain understanding, and I hope that it can be helpful to everyone.